Reverse Override Switch; Front Drive Actuator; Stator Coil - Arctic Cat Wildcar Trail Service Manual

2WD
C to E 50 ohms ± 10% C to E 50 ohms ± 10% C to E 50 ohms ± 10%
A to B Open A to B <1 ohm
A to C Open A to C Open
A to E Open A to B <1 ohm
VOLTAGE
 NOTE: Voltage tests must be made with the switch
and the actuator connected. The meter can be con-
nected at the actuator connector using a break-out
harness or MaxiClips.
1. Turn the ignition switch to the ON position.
2. Select the DC Volts position on the tester and observe
the meter readings for each of the three switch positions.
WIRE COLOR 2WD
Black to Orange 12.0 DC Volts 12.0 DC Volts
Black to White/ 11.5 DC Volts 0 DC Volts
Green
Black to White/ 11.5 DC Volts 11.5 DC Volts
Orange
 NOTE: If the meter does not show voltages accord-
ing to the chart, make sure the front drive actuator is
plugged in; then troubleshoot the switch, ignition
fuses, battery connections, or wiring harness.

Reverse Override Switch

VOLTAGE
 NOTE: To perform the following tests, the ignition
switch must be in the ON position and the transmis-
sion shifted into reverse gear.
1. Connect the red meter lead to the red/green wire and
the black meter lead to a suitable ground; then select
2WD on the drive select switch. The meter must show
approximately 1.5 DC volts.
2. Depress the reverse override switch. The meter show-
ing should not change from step 1.
3. Select 4WD on the drive select switch. The meter
must show approximately 5 DC volts.
4. Depress the reverse override switch. The meter must
show approximately 1.5 DC volts.
PR566A
DIFFERENTIAL
4WD
LOCK
A to B <1 ohm
A to C <1 ohm
A to C <1 ohm
4WD DIFFERENTIAL LOCK
12.0 DC Volts
0 DC Volts
0 DC Volts

Front Drive Actuator

 NOTE: With the engine stopped and the ignition switch
in the ON position, a momentary "whirring" sound must
be noticeable each time the drive select switch is moved
to 2WD and 4WD. Test the switch, 30 amp fuse, and wir-
ing connections prior to testing the actuator.
VOLTAGE
1. Locate the 4-wire connector for the front drive actua-
tor above the differential; then connect the red meter
lead to the orange wire using a MaxiClip.
2. Connect the black lead to the black wire using a MaxiClip;
then select 2WD on the drive select switch.
 NOTE: The black tester lead can remain connected
to the black wire for the remaining tests.
3. Turn the ignition switch to the ON position. The meter
must show battery voltage.
 NOTE: If battery voltage is not shown, troubleshoot the
10 amp ignition (IGN) fuse on the power distribution
module, the ignition switch, or the main wiring harness.
4. Connect the red meter lead to the white/green wire.
The meter must show battery voltage.
5. Select 4WD on the drive select switch. The meter
must show 0 DC volts.
6. Connect the red meter lead to the white/orange wire.
The meter must show battery voltage.
7. Select LOCK on the drive select switch. The meter
must show 0 DC volts.

Stator Coil

 NOTE: The cargo box must be removed for this pro-
cedure.
VOLTAGE (AC Generator - Regulated
Output)
 NOTE: The battery must be at full charge for these
tests.
WT561
95