Wireless ADSL VPN Router User Guide
Physical Details
Front-mounted LEDs
Power LED
On - Power on.
(Green)
Off - No power.
Status LED
Off - Normal operation.
(Yellow)
Blinking - This LED blinks during start up, and during a Firmware
Upgrade.
LAN
For each port, there are 2 LEDs, to indicate the connection speed
(10BaseT or 100BaseT) of each port.
•
100BT - This will be ON if the LAN connection is using
100BaseT, and Blinking if data is being transferred via the
corresponding LAN port.
•
10BT - This will be ON if the LAN connection is using 10BaseT,
and Blinking if data is being transferred via the corresponding
LAN port.
•
If neither LED is on, there is no active connection on the
corresponding LAN port.
WLAN LED
On - Wireless enabled.
Off - No Wireless connections currently exist.
Flashing - Data is being transmitted or received via the Wireless
access point. This includes "network traffic" as well as user data.
WAN
On - ADSL connection established. (This is a low-level connection,
it does not mean Internet access is available.)
Off - No ADSL connection currently exists.
Flashing - Data is being transmitted or received via the ADSL
connection.
Internet
On - Internet connection is available.
Off - No Internet connection available.
Flashing - Data is being transmitted or received via the ADSL
connection.
Figure 2: Front Panel
6