Table of Contents
Advertisement
Wireless ADSL VPN Router User Guide
Local LAN
This identifies which PCs on your LAN are covered by this
Local LAN
policy. For each selection, data must be provided as follows:
•
•
The remote VPN endpoint must have these IP addresses
entered as its "Remote" addresses.
Remote LAN
Remote LAN
This identifies which PCs on the remote LAN are covered by
this policy. For each selection, data must be provided as
follows:
•
•
•
The remote VPN endpoint must have these IP addresses
entered as its "Local" addresses.
ESP Configuration
SPI
Enter the required SPIs. Each policy must have unique SPIs.
These settings must match the remote VPN endpoint. Note
that the "in" setting here must match the "out" setting on the
remote VPN endpoint, and the "out" setting here must match
the "in" setting on the remote VPN endpoint.
Encryption
Select the desired Encryption Algorithm, and enter the key in
the field provided.
•
•
Single address
Enter an IP address in the "IP address" field. Typically, this
setting is used when you wish to make a single Server on
your LAN available to remote users.
Subnet address
Enter an IP address in the "IP address" field, and the
desired network mask in the "Subnet Mask" field.
Single PC - no subnet
Select this option if there is no LAN (only a single PC) at
the remote endpoint. If this option is selected, no additional
data is required.
Single address
Enter an IP address in the "IP address" field. This must be
an address on the remote LAN. Typically, this setting is
used when you wish to access a server on the remote
LAN.
Subnet address
Enter an IP address in the "IP address" field, and the
desired network mask in the "Subnet Mask" field.
For DES, the key should be 8 ASCII characters (16 Hex
characters).
For 3DES, the key should be 24 ASCII characters (48 Hex
characters).
82
Advertisement
Table of Contents
