Table of Contents
Advertisement
Setup
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is
shown below.
Data - LAN Screen
TCP/IP
IP address for the Wireless ADSL Router, as seen from the local
IP Address
LAN. Use the default value unless the address is already in use
or your LAN is using a different IP address range. In the latter
case, enter an unused IP Address from within the range used by
your LAN.
Subnet Mask
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the Wireless ADSL Router is attached (the
same value as the PCs on that LAN segment).
•
DHCP Server
•
•
See the following section for further details on using DHCP.
Figure 6: LAN Screen
If Enabled, the Wireless ADSL Router will allocate IP
Addresses to PCs (DHCP clients) on your LAN when they
start up. The default (and recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the Wireless ADSL Router as the default
Gateway. See the following section for further details.
The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP
Addresses to DHCP clients. This range also determines the
number of DHCP clients supported.
15
Advertisement
Table of Contents
