LevelOne WBR-3407 User Manual page 52

11g wireless adsl vpn router
Hide thumbs Also See for WBR-3407:
Table of Contents

Advertisement

Operation and Status
Data - Status Screen
System
Device Name
Firmware Version
ADSL
Modem Status
DownStream
Connection Speed
UpStream
Connection Speed
VC 1 Status
VC 2 Status
VC 3 Status
VC 4 Status
ADSL
Details
Internet (VC1)
Connection Method
Connection Status
Internet IP Address
Connection Details
LAN
IP Address
Network Mask
DHCP Server
The current name of the Router. This name is also the
"hostname" for users with an "@Home" type connection.
The version of the current firmware installed.
This indicates the status of the ADSL modem component.
Displays the speed for the DownStream Connection.
If connected, displays the speed for the Up Stream (upload)
ADSL Connection.
For each VC (Virtual Circuit), the current status is
displayed. This will be either "Enabled" or "Disabled".
Note: VC 1 is a standard (Routed) Internet connection. VC
2, VC 3 and VC 4 are Bridge-mode connections.
Click this button to open a sub-window and view the details
of each VC (Virtual Circuit).
Displays the current connection method, as set in the Setup
Wizard.
This indicates the current status of the Internet Connection
Active - Connection exists
Idle - No current connection, but no error has been
detected. This condition normally arises when an idle
connection is automatically terminated.
Failed - The connection was terminated abnormally.
This could be caused by Modem failure, or the loss of
the connection to the ISP's server.
If there is an error, you can click the "Connection Details"
button to find out more information.
This IP Address is allocated by the ISP (Internet Service
Provider). If using a dynamic IP address, and no connection
currently exists, this information is unavailable.
Click this button to open a sub-window and view a detailed
description of the current connection. Depending on the
type of connection, a "log" may also be available.
The IP Address of the Wireless ADSL Router.
The Network Mask (Subnet Mask) for the IP Address
above.
This shows the status of the DHCP Server function. The
value will be "Enabled" or "Disabled".
49

Advertisement

Table of Contents
loading

Table of Contents