Table of Contents
Advertisement
Wireless ADSL VPN Router User Guide
If you can't connect
If the Wireless ADSL Router does not respond, check the following:
•
The Wireless ADSL Router is properly installed, LAN connection is OK,
and it is powered ON. You can test the connection by using the "Ping"
command:
•
Open the MS-DOS window or command prompt window.
•
Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or
your PC's IP address is not compatible with the Wireless ADSL
Router's IP Address. (See next item.)
•
If your PC is using a fixed IP Address, its IP Address must be within the
range 192.168.0.2 to 192.168.0.254 to be compatible with the Wireless
ADSL Router's default IP Address of 192.168.0.1. Also, the Network
Mask must be set to 255.255.255.0. See Chapter 4 - PC Configuration
for details on checking your PC's TCP/IP settings.
•
Ensure that your PC and the Wireless ADSL Router are on the same
network segment. (If you don't have a router, this must be the case.)
•
Ensure you are using the wired LAN interface. The Wireless interface
can only be used if its configuration matches your PC's wireless
settings.
Setup Wizard
The first time you connect to the Wireless ADSL Router, the Setup Wizard will run
automatically. (The Setup Wizard will also run if the Wireless ADSL Router's default
settings are restored.)
1. Step through the Wizard until finished.
•
You need the data supplied by your ISP. Most connection methods require
some data input.
•
The common connection types are explained in the following table.
2. On the final screen of the Wizard, run the test and check that an Internet
connection can be established.
3. If the connection test fails:
•
Check all connections, and the front panel LEDs.
•
Check that you have entered all data correctly.
12
Advertisement
Table of Contents
