Table of Contents
Advertisement
Off / Relay Output to trigger other device.
Dwell Time
Set the recording period from the start of the sensor input activation. During this period, the corresponding
camera video will record according to the frame and alarm (relay) output set. The recording stops and alarm
output is turned off when the dwell time has elapsed.
Copy Setting
Upon pressing Copy Settings button, Copy Settings popup will appear. In this popup, choose the sensor the user
wants to copy from at the "From" field. Choose the parameters such as Type, Cam, Notify, Preset, Relay, and
Dwell Time on the check box. Check on the checkbox next to the sensor numbers to apply the copy setting(s) to
another channel on the "To" box.
N
"Sensor" here means the alarm connected to the NVR, which is triggered by a physical sensor input or
OTE
transmitted data from network camera sensor input
N
OTE
If the sensor does not operate properly, check the setting of the sensor type (N/O or N/C). The alarm might
not function if the actual connecting sensor type and the sensor type in the system setting are inconsistent.
There are three options to choose from to notify of Camera Input Sensor – All, Beep and Cam pop-up.
N
OTE
"Beep" means that beep sounds automatically when an alarm is triggered.
"Cam pop-up" means that multi-screen live video mode will be switched automatically to single channel
mode when an alarm is triggered. This single channel video will be the channel triggered by alarm.
"All" means that "Beep" and "Cam pop-up" will be used simultaneously
when an alarm is triggered.
User's Manual | 48
Advertisement
Table of Contents
