Miele TX3587 Operating And Installation Instructions page 36

Using for the first time
The prompt for water intake appears
and the triangle V flashes:
?
;
^ Open the door.
^ Pull the water intake pipe forwards
(located below the control panel on
the left).
^ Place the end of the water intake
pipe in the water container.
36
^ Touch the OK sensor.
The water intake process will begin.
The amount of water required will be
drawn up into the oven. The quantity of
water specified is higher than actually
required, leaving a small amount in the
container.
^ Remove the water container after the
water intake process.
^ Close the door.
You will hear the pump briefly as the
remaining water in the water intake pipe
is drawn into the oven.
The oven heating will switch on.
After a short time, a burst of steam is
injected automatically.
,
Danger of injury!
Steam can cause injury by scalding.
Do not open the appliance door
while a burst of steam is being
injected.
Heat up the oven for at least 1 hour.
After at least an hour:
^ Turn the function selector to ß.