Miele KM 3010 Operating And Installation Instructions
Gas hobs
Hide thumbs
Also See for KM 3010:
- Operating and installation instructions (52 pages) ,
- Operating and installation instructions (48 pages) ,
- Operating and installation instructions (60 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Chapters
Table of Contents
Related Manuals for Miele KM 3010
Summary of Contents for Miele KM 3010
- Page 1 Operating and installation instructions Gas hobs KM 3010 KM 3014 en - GB To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.
- Page 2 Per questo se si vuole usare l’apparecchio in un paese diverso rivolgersi al servizio di assistenza tecnica Miele del paese in cui si intende usarlo.
- Page 3 Gas-heated appliances Safety precautions to take if you smell gas ß Turn off the gas emergency control valve immediately. This is usually located near the gas meter. ß Eliminate all sources of ignition in a safe manner. Do not smoke, light cigarette lighters or matches. ß...
-
Page 4: Table Of Contents
KM 3010........ -
Page 5: Description Of The Appliance
Description of the appliance KM 3010 a Large burner Cooking zone controls: b Small burner g Front right cd Medium burners h Rear right e Pan support (for each burner) i Rear left f Cooking zone symbol j Front left... - Page 6 Description of the appliance KM 3014 a Wok burner Cooking zone controls: b Small burner f Front right c Medium burner g Rear right d Pan support (for each burner) h Left e Cooking zone symbol...
- Page 7 Description of the appliance Burner Wok burner a Outer burner cap b Inner burner cap c Burner head d Burner base e Ignition safety device f Ignitor Small, medium and large burners a Burner cap b Burner head c Burner base d Ignition safety device e Ignitor...
-
Page 8: Accessories Supplied
Description of the appliance Accessories supplied The accessories supplied with your appliance as well as a range of optional ones are available to order from Miele (see "Optional accessories"). Wok ring (only for KM 3014) The Wok ring supplied with your appliance can be used in instances where extra stability is required. -
Page 9: Warning And Safety Instructions
Any other use is not supported by the manufacturer and could be dangerous. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The gas hob is not intended for outdoor use. - Page 10 Warning and Safety instructions Safety with children This appliance is not a toy! To prevent the risk of injury, do not allow children to play with the appliance or its controls. Children under 8 years of age must be kept away from the hob unless they are constantly supervised.
- Page 11 It is most important that this basic safety requirement is observed and tested regularly, and where there is any doubt, the household wiring system should be inspected by a qualified electrician. Miele cannot be held liable for the consequences of an inadequate earthing system (e.g. electric shock).
- Page 12 The hob is not intended for use with an external timer switch or a remote control system. If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Spare Parts Department.
- Page 13 Warning and Safety instructions Do not connect the appliance to the mains electricity supply by a multi-socket adapter or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). Do not use the hob if if it is faulty, or if the ceramic surface is cracked, chipped or damaged in any way.
- Page 14 If the pan diameter is too large, flames can spread out to the sides and damage or burn the worktop, wall claddings or surrounding units and also parts of the hob. Miele cannot be held liable for this type of damage.
- Page 15 Warning and Safety instructions Ensure that the flames from the burner do not spread out beyond the base and up the sides of the pan. Unless the pan manufacturer states that you can do so, do not use pans with very thin bases on this hob, and never heat up empty pans as they could get damaged.
- Page 16 If the appliance has not been used for a longer period of time it should be thoroughly cleaned before it is used again. It is also advisable to have the appliance tested for safety. Miele cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions.
-
Page 17: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials often contain materials which, if which are environmentally friendly for handled or disposed of incorrectly, disposal and should be recycled. -
Page 18: Before Using For The First Time
Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service, data plate" section of this booklet. Cleaning for the first time ^ Remove any protective foil. ^ Clean all removable parts of the burners with a solution of warm water and a little washing-up liquid applied with a soft sponge. -
Page 19: Operation
Operation Controls The control is used to ignite the burner and to regulate the strength of the flame. Small, medium and large burners ß The gas supply is turned off & Strongest flame / Weakest flame Wok burner ß The gas supply is turned off &/ Strongest flame: The inner and outer burners operate at the highest setting. -
Page 20: Switching On
Operation Switching on ^ The control for the burner required must be pressed in and turned anti-clockwise to the largest flame symbol to switch When a control is operated, a spark is produced on all cooking zones. This is not a fault. ^ When the flame ignites, keep the control pressed in for 5-10 seconds, and then let it go. -
Page 21: Regulating The Flame
Operation Regulating the flame Regulate the flame so that it does not spread out beyond the sides of the pan. As the outer part of the flame is much hotter than the centre, the tips of the flames should stay beneath the pan base. -
Page 22: Suitable Pans
Suitable pans Burner Min. pan base diameter in cm Small burner Medium burner Large burner Wok burner Max. diameter at top of pan in cm Small burner Medium burner Large burner Wok burner – Refer to the chart above and ensure that the pan diameter falls within the minimum and maximum diameters given for the burner you are using. -
Page 23: Combi Insert
Suitable pans Combi insert The combi insert must be utilised when using pans with a base diameter of less than the minimum given in the table above. The combi insert ensures that the pan will sit securely on the hob, and cannot tip up. Wok ring The Wok ring supplied with your appliance can be used in instances where extra stability is required. -
Page 24: Energy Saving Tips
Energy saving tips – Use a pan lid whenever possible to minimise heat loss. – Cook with as little water as possible. – Cooking times are greatly reduced when using a pressure cooker. – Turn the flame down promptly to a lower setting when the pan has come to the boil. -
Page 25: Safety Features
Safety features Thermo-electric ignition safety device This appliance is has a thermo-electric ignition safety device. If the flame goes out, for example if food has boiled over or if there is a sudden draught, and automatic re-ignition has been unsuccessful, the supply of gas to the burner will be cut off, preventing any further escape of gas. -
Page 26: Cleaning And Care
Cleaning and care Do not use a steam cleaning appliance to clean this appliance. The steam could reach electrical components and cause a short circuit. – The appliance should be cleaned after each use. Allow the appliance to cool down to a safe temperature before cleaning. -
Page 27: Cleaning Instructions
It will form an invisible coating which will cause permanent Clean with Miele ceramic glass and stainless steel discolouration of the cleaner (see "Optional Accessories"), or with ceramic surface which another proprietary ceramic glass cleaner and cannot be removed. - Page 28 Cleaning and care To assemble the small, medium and large burners ^ Place the burner head b on to the burner base c so that the ignition safety device d and the ignitor e extend through their respective holes in the burner head. The burner head must click into place correctly.
- Page 29 Cleaning and care To assemble the wok burner ^ Place burner head c onto burner base d so that the ignition safety device e and the ignitor f extend through their respective holes in the burner head. The burner head must click into place correctly.
-
Page 30: Problem Solving Guide
The burner head or burner cap Remove any soiling. holes are dirty. The ignitor on the Check whether the mains fuse Call a suitably qualified electrician or Miele burner does not has tripped. Service. spark. The gas can be lit with a match (See "Switching on in a power cut"). -
Page 31: Optional Accessories
Optional accessories Miele offer a comprehensive range of useful accessories as well as cleaning and conditioning products for your appliance. These products can be ordered online: or from Miele (see back cover for contact details) Ceramic and stainless steel hob cleaner... -
Page 32: Safety Instructions For Installation
Safety instructions for installation Do not use any sealant except Fit the wall units and extractor hood where expressly instructed to do so. before fitting the hob to avoid The seal underneath the appliance damaging the surface. provides a sufficient seal for the worktop. - Page 33 Safety instructions for installation Safety distance above the appliance A minimum safety distance must be maintained between the appliance and the cooker hood above it. See the cooker hood manufacturer's operating and installation instructions for details. If the manufacturer's instructions are not available for the cooker hood, a minimum safety distance of at least 760 mm must be maintained.
- Page 34 Safety instructions for installation Safety distances to the sides of the Ideally the hob should be installed with plenty of space on either side. There may be a wall at the rear or a tall unit or wall on one side (right or left) (see illustrations).
-
Page 35: Appliance And Building-In Dimensions
Appliance and building-in dimensions KM 3010 a Front b Casing depth c Casing depth including mains connection box d Gas connection R 1/2 - ISO 7-1 (DIN 10226) - Page 36 Appliance and building-in dimensions KM 3014 a Front b Casing depth c Casing depth including mains connection box d Gas connection R 1/2 - ISO 7-1 (DIN 10226)
-
Page 37: Installation
Installation ^ Make the worktop cut-out according to the dimensions given in the building-in dimension diagram. Remember to maintain the minimum safety distances (see "Safety instructions for installation"). ^ Seal the cut surfaces on wood/laminated worktops with a suitable heat-resistant sealant to avoid swelling caused by moisture. -
Page 38: Tiled Worktop
Installation Seal between appliance and Tiled worktop worktop Grout lines a and the hatched area The sealing strip under the edge of the underneath the hob frame must be top part of the appliance provides a smooth and even. If they are not the sufficient seal for the worktop. -
Page 39: Electrical Connection
Electrical connection Connection should be made via a All electrical work should be carried suitable isolator or a double pole fused out by a suitably qualified and spur connection unit which complies competent person, in strict with national and local safety accordance with current local and regulations and the on/off switch should national safety regulations (BS 7671... - Page 40 If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Service Department. The manufacturer cannot be held liable for damage which is the direct or indirect result of incorrect installation or connection.
-
Page 41: Gas Connection
Please contact your dealer or the Miele Spare Parts Department for the Check with your local gas supplier appropriate conversion jets if about the type of gas and its necessary. - Page 42 Gas connection Connection Using a 90° angle The gas connection must be installed so that connection can be made either from inside or outside the kitchen unit, and the isolating valve must be easily accessible and visible (by opening one of the kitchen doors, if necessary).
-
Page 43: Burner Ratings
Liquid gas 0.35 Large burner Natural gas H 0.50 Liquid gas 2.55 0.60 Natural gas H 0.30 Liquid gas 0.40 KM 3010 Natural gas H 7.10 Total Liquid gas 6.90 KM 3014 Natural gas H 7.40 Total Liquid gas 7.25... -
Page 44: Conversion To Another Type Of Gas
Conversion to another type of gas Connection to the gas supply, or conversion from one type of gas to another, should only be undertaken by an approved and registered gas installer in strict accordance with local and national safety and building regulations (e.g. -
Page 45: To Change The Main Jets
Conversion to another type of gas Changing the jets Disconnect the gas hob from the mains electricity supply. Turn off the gas supply. To change the main jets Small, medium and large burners ^ Remove the pan support, burner cap a and burner head ^ Using an M7 socket spanner, unscrew the main jet f ^ Fit the correct jets securely (see jet table). -
Page 46: Wok Burner
Conversion to another type of gas Wok burner ^ Remove burner cap ab and burner head c. ^ Using an M7 socket spanner, unscrew the main jet d ^ Fit the correct jets securely (see jet table). ^ Finally, secure the jets against inadvertent loosening with sealing wax. -
Page 47: To Change The Small Jets
Conversion to another type of gas To change the small jets To change the small jets, the burner securing screws must first be loosened and the upper section of the appliance removed. ^ Pull the control knobs off. ^ Remove the cover (see illustration). ^ Lift the top of the appliance off. -
Page 48: Function Test
Conversion to another type of gas Function test Check all gas fittings for leaks. ^ Reassemble the appliance. ^ Check the burner flame by operating the burner. The flame must not go out on the lowest setting, or when the control is turned quickly from a high to a low setting. On the highest setting, the flame must have a distinctive and visible core. -
Page 49: After Sales Service, Data Plate, Guarantee
Guarantee For information on the appliance guarantee specific to your country please contact Miele. See back cover for contact details. In the UK, your appliance is guaranteed for 2 years from the date of purchase. However, you must activate your cover by calling 0845 365 6640 or registering online at www.miele.co.uk. - Page 52 Alteration rights reserved / 4212 M.-Nr. 09 168 420 / 02...