Rear Wheel (For Non-Abs Models) - Yamaha Tenere XT660Z Owner's Manual

7. Retighten pinch bolt A to the
specified torque.
Tightening torques:
Wheel axle:
59 Nm
Front wheel axle pinch bolt:
18 Nm
Brake caliper bolt:
40 Nm
8. Apply the brake lever several
times, and then while holding the
brake lever in, push down hard on
the handlebar several times to
check for proper fork operation.
PERIODIC MAINTENANCE AND ADJUSTMENT
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
6-37
EAU44802
EWA14841
EAU56711
ZAUM1267
1. Wheel axle nut
2. Drive chain slack adjusting bolt
3. Locknut
EWA10822
4. Drive chain
2. Lift the rear wheel off the ground
according to the procedure on
page 6-35.
3. Remove the axle nut.
4. Fully loosen the locknut on each
side of the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a) and
push the wheel forward.
6