Yamaha Tenere XT660Z Owner's Manual page 56

PERIODIC MAINTENANCE AND ADJUSTMENT
6. Remove the oil filter element drain
bolt to drain the oil from the oil fil-
ter element.
TIP
Skip steps 7–9 if the oil filter element is
not being replaced.
7. Remove the oil filter element cover
by removing the bolts.
6
1. Oil filter element drain bolt
2. Oil filter element cover bolt
8. Remove and replace the oil filter
element and O-rings.
TIP
Make sure that the O-rings are properly
seated.
1. Oil filter element
2. O-ring
9. Install the oil filter element cover
by installing the bolts.
10. Install the oil filter element drain
bolt.
11. Tighten the oil filter element cover
bolts and the oil filter element
drain bolt to their
torques.
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
12. Install the engine oil drain bolts,
and then tighten them to their
specified torques.
6-12
Tightening torques:
Engine oil drain bolt (crankcase):
30 Nm
Engine oil drain bolt (oil tank):
18 Nm
13. Add the specified amount of the
recommended engine oil, and
then install and tighten the oil filler
cap.
NOTICE
The engine oil tank must be filled in
2 steps. First, fill the engine oil tank
with 1.90 L (2.0 US qt, 1.67 Imp.qt) of
the recommended engine oil. Then,
start the engine, race it 5 or 6 times,
turn it off, and then add the remain-
der of the engine oil.
specified
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
2.50 L (2.64 US qt, 2.20 Imp.qt)
With oil filter element replacement:
2.60 L (2.75 US qt, 2.29 Imp.qt)
ECAM1063