Yamaha Tenere XT660Z Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 7500 r/min and above
3
Tripmeter and tachometer modes
1. Odometer
2. Tripmeter/fuel reserve tripmeter
3. "SELECT" button
4. "RESET" button
Pushing the "SELECT" button switch-
es the display between the tripmeter
modes "TRIP 1" and "TRIP 2" in the
following order:
TRIP 1 → TRIP 2 → TRIP 1
When the fuel amount in the fuel tank
ECA10032
decreases to XT660Z 6.7 L (1.77 US
gal, 1.47 Imp.gal) - XT660ZA 5.8 L
(1.53 US gal, 1.28 Imp.gal), the bottom
segment of the fuel meter starts flash-
ing, and the tripmeter display automat-
ically changes to the fuel reserve
tripmeter mode "F-TRIP" and starts
counting the distance traveled from
that point. In that case, pushing the
"SELECT" button switches the display
between the various tripmeter modes
in the following order:
F-TRIP → TRIP 1 → TRIP 2 → F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
four seconds. If you do not reset the
fuel reserve tripmeter manually, it re-
sets itself automatically and the display
returns to the prior mode after refueling
and traveling 5 km (3 mi).
Clock mode
1. Clock
2. "SELECT" button
3. "RESET" button
TIP
The clock always shows the time re-
gardless of the main switch position.
To set the clock:
1. Push the "SELECT" button for at
2. When the hour digits start flash-
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
3-7
least four seconds.
ing, push the "RESET" button to
set the hours.
the minute digits start flashing.
the minutes.