Rear Wheel (For Non-Abs Models) - Yamaha MT09 Owner's Manual

Periodic maintenance and adjustment
1 Rear wheel (for non-ABS
models)
2
WARNING
For the ABS model, have a Yamaha
3
dealer remove and install the wheel.
4
5
To remove the rear wheel
6
WARNING
To avoid injury, securely support the
7
vehicle so there is no danger of it
falling over.
8
1. Loosen the axle nut.
9
10
11
12
EAU44802
EWA14841
1
EAU56701
1. Axle nut
2. Lift the rear wheel off the ground
EWA10822
according to the procedure on
page 6-39.
3. Remove the axle nut.
4. Fully loosen the locknut on each
side of the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a) and
push the wheel forward.
1. Drive chain slack adjusting bolt
2. Locknut
TIP


6-41
1 2
(a)
6. Remove the drive chain from the
rear sprocket.
If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
The drive chain cannot be disas-
sembled.
7. While supporting the brake caliper
bracket, pull the wheel axle out,
and then remove the wheel.
NOTICE: Do not apply the brake
after the wheel and brake disc