Cleaning And Lubricating The Drive; Chain - Yamaha Tenere XT660Z Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
occurring, keep the drive chain
slack within the specified limits.
[ECA10572]
6
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Alignment marks
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
Tightening torques:
Axle nut:
104 Nm
Locknut:
16 Nm
4. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and the drive

chain

smoothly.
6-24
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
moves
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
EAU23026
ECA10584
[ECA11122]