Table of Contents
Advertisement
MEITRACK MVT380 User Guide
To install the SIM card, perform the following operations:
1.
Loosen the screw, and remove the front cover of the MVT380.
2.
Insert the SIM card to the slot. Ensure that the card chip is facing up to the Printed Circuit Board (PCB).
3.
Close the cover, and tighten the screw.
6.2 Charging
When you use the MVT380 for the first time, connect the MVT380 GND (-Black) and Power (+Red) wires to 12 V or 24 V external
power supply for charging. Ensure that the MVT380 is charged at least three hours. Eight hours are recommended.
The MVT380 can be installed on a vehicle only after it is configured and tested.
6.3 Indicator
Press and hold down the power button for 3s to 5s to start the MVT380.
GPS Indicator (Blue)
Steady on
Blink (every 0.1s)
Blink (0.1s on and 2.9s off)
Blink (1s on and 2s off)
GSM Indicator (Green)
Steady on
Blink (every 0.1s)
Blink (0.1s on and 2.9s off)
Blink (1s on and 2s off)
6.4 Location Tracking
Call the MVT380 SIM card number. An SMS with a map link will be received.
Click the SMS link. The location will be displayed on Google Maps on your mobile phone.
Copyright © 2015 Meitrack Group All rights reserved.
One button is pressed or one input is activated.
The MVT380 is being initialized or the battery power is
low.
A GPS signal is received.
No GPS signal is received.
A call is coming in or a call is being made.
The MVT380 is being initialized.
A GSM signal is received.
No GSM signal is received.
- 7 -
Advertisement
Table of Contents
