Table of Contents
Advertisement
MEITRACK MVT380 User Guide
10 (OUT2)
Yellow
11 (OUT3)
Yellow
12 (OUT4)
Yellow
13 (OUT5)
Yellow
14 (AD2)
Blue
15 (GND)
Black
16 (POWER)
Red
8.1.1 Power Cable/Ground Wire (PIN7, PIN8)
Connect the power cable (red) and ground wire (black) to the positive and negative electrodes of the vehicle battery
respectively.
Copyright © 2015 Meitrack Group All rights reserved.
power supply.
Output 2
Valid: low level (0 V)
Invalid: open drain
Maximum voltage for output open drain (invalid): 45 V
Maximum current for output low voltage (valid): 500 mA
Connects to an external relay to remotely cut off the vehicle fuel cable or engine
power supply.
Output 3
Valid: low level (0 V)
Invalid: open drain
Maximum voltage for output open drain (invalid): 45 V
Maximum current for output low voltage (valid): 500 mA
Connects to an external relay to remotely cut off the vehicle fuel cable or engine
power supply.
Output 4
Valid: low level (0 V)
Invalid: open drain
Maximum voltage for output open drain (invalid): 45 V
Maximum current for output low voltage (valid): 500 mA
Connects to an external relay to remotely cut off the vehicle fuel cable or engine
power supply.
Output 5
Valid: low level (0 V)
Invalid: open drain
Maximum voltage for output open drain (invalid): 45 V
Maximum current for output low voltage (valid): 500 mA
Connects to an external relay to remotely cut off the vehicle fuel cable or engine
power supply.
Analog input 2 with 10-bit resolution and valid voltage of 0–6 V.
Connects to an external sensor, such as the fuel sensor and temperature sensor.
Ground wire
It can be used as a ground wire connected to an analog sensor.
Positive pole of the power output. The output voltage is equal to that of pin 8.
Supplies power to an external device.
- 13 -
Advertisement
Table of Contents
