Name
ESC 3
ESC A
ESC b
Page Format
Name
ESC C 0
ESC C
ESC N
ESC O
Printer Control
Name
ESC s
ESC EM
ESC B
FF
Dec
Hex
27 51 n
1B 33 n
27 65
1B 41
27 98 m
1B 62 m
n1...n16 0
n1...n8 00
Dec
Hex
27 67 0 m
1B 43 00 m
27 67 n
1B 43 n
27 78 n
1B 4E n
27 79
1B 4F
Dec
Hex
27 115
1B 73
27 25 n
1B 19 n
27 66 0 n1
1B 42 0 n1,
n2...n16 0
n2...n16 00
12
0C
Section 4: Epson Emulation Mode Printer Commands
Description
Set Graphics Line Spacing - 248x only
Use a line spacing of 24/216 for bit-image graphics
using 8 bits. n must be a 1-byte decimal value from
0 to 255. To move exactly n/216 inch per line, n
must be an integer multiple of 3.
Set Graphics Line Spacing - 249x only
Sets line spacing to n/180 inches per line.
Set n/72 Inch Line Spacing
Sets line spacing to n/72 inch for subsequent line
feed command. The value of n must be between 0
and 85.
Set Vertical Tabs in Channel
Sets vertical tab stops in specified channel by m.
m must be a one-byte decimal value from 0 to 7.
Description
Set Page Length to m Inches
Set Page Length to n Lines
Set Skip Perforation
Creates a bottom margin by skipping n lines. Valid
values of n are 0 through 255.
Cancel Skip Perforation
Cancels the skip perforation function.
Description
Turn Half Speed Mode On/Off -248x only
Auto Sheet Feeder On/Off
n=0 Off
n=4 On
n=R Eject
Set Vertical Tab Stops
Sets up to 16 tab stops. The sequence ends with 0.
Form Feed
Advances the paper to the top of the next page.
75
Need help?
Do you have a question about the FORMS 249X and is the answer not in the manual?