Lexmark C912 User Reference Manual page 106

Message
Programming Error P<x>
Queuing and Deleting
Jobs
Queuing Jobs
Ready
Ready Hex
Remove Paper <specified
bin>
Resetting
Maint Cnt Value
Resetting the Printer
Understanding printer messages
What this message means
An error occurred while the
printer was programming code
into memory.
The printer is deleting one or
more held jobs and sending one
or more jobs to print.
The printer is sending one or
more held jobs to print.
The printer is ready to receive
and process print jobs.
The printer is in Hex Trace mode
and is ready to receive and
process print jobs.
The specified output bin, or bins,
is full.
The printer is resetting the
counter that tracks wear on the
fuser.
The printer is resetting to the
current default settings. Any
active print jobs are canceled.
Understanding printer messages
101
What you can do
Correct the problem specified on the
second line of the display:
• P105—A network file was used to
program a non-network printer, or
a non-network file was used to
program a network printer.
• P109—An update file was used to
program the printer, but the
information did not fit within the
space allocated in the Master Boot
Record.
• P112—An upddle.fls file was used
to update the DLE code on a
printer with a firmware card
installed, but the DLE was not
found on the firmware card.
• P200—No firmware card is
installed.
Wait for the message to clear.
See also: Printing and deleting
held jobs
Wait for the message to clear.
See also: Using the Print and Hold
function
Send a job to print.
• Send a job to print. All data sent to
the printer is printed in
hexadecimal and character
representation. Control strings are
printed, not executed.
• Turn the printer off and then on to
exit Hex Trace mode and return to
Ready status.
Remove the stack of paper from the
specified bin(s) to clear the
message.
Wait for the message to clear.
Wait for the message to clear.