Lexmark C912 User Reference Manual page 102

Message
Formatting Disk
yyy%
Formatting Flash
Fuser
Maintenance
Held Jobs May Be
Lost
Held Jobs May
Not Be Restored
Infrared <x>
Insert Tray <x>
Understanding printer messages
What this message means
The printer is formatting the hard
disk. When formatting takes
longer than usual, the second
line of the display shows the
percent complete.
The printer is formatting the flash
memory.
The counter that tracks wear on
the fuser has reached its limit.
The printer memory is too full to
continue processing print jobs.
The printer memory cannot
restore Print and Hold jobs from
the printer hard disk.
An infrared interface is the active
communication link.
The specified tray is either
missing or not fully inserted.
Understanding printer messages
97
What you can do
Wait for the message to clear.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear.
Warning: Do not turn the printer off
while this message is displayed.
• Press Go to continue printing.
• If print quality is unacceptable,
replace the fuser.
See also:
Replacing the fuser
• Press Go to clear the message
and continue printing. The printer
frees memory by deleting the
oldest held job and continues
deleting held jobs until there is
enough printer memory to process
the job.
• Press Stop to clear the message
without deleting any held jobs.
The current job may not print
correctly.
• Press Menu to open the Job Menu
and cancel the current job.
• To avoid this error in the future:
– Delete fonts, macros, and other
data stored in printer memory.
– Install more printer memory.
– Note: The messages 37
Insufficient Memory and Held
Jobs may be lost alternate on the
display.
See also:
Using the Print and Hold
37 Insufficient Memory
Press Go to clear the message.
Some of the Print and Hold jobs
stored on the disk will not be
restored.
Insert the specified tray completely.
See also:
Loading a paper tray
function;