General Glass Information - Kingsman ZDV3624 Installation Instructions Manual

Glass Cleaning
It will be necessary to clean the glass periodically. During start-up,
condensation, which is normal, forms on the inside of the glass and
causes dust, lint etc. to cling to the glass surface. Also, initial paint
curing can deposit a slight film on the glass. It is therefore recom-
mended that initially the glass be cleaned two or three times with
non-abrasive common household glass cleansers and warm water. After
that, the glass should be cleaned two or three times a season depending
on the circumstances.
Cautions and Warnings
• Do not clean when the glass is hot.
• The use of substitute glass will void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass front or with a broken
glass front.
• Do not strike or abuse glass.
Appliance/Log Reference Chart/Log Placement
The following is a list of models and appropriate log sets that can be used with each model. It is important that the appropriate log set is used
with the correct model in order for the appliance to work properly.
Appliance
ZDV3624N or LP
ZDV3624NB or LPB
ZDV3628N or LP
ZDV3632N or LP

General Glass Information

Glass Replacement
REPLACEMENT GLASS FOR BOTH DIRECT VENT UNITS
Model Series ZDV3624 can use either tempered glass or Robax
ceramic or coated Neaoceram glass. Must be 5mm thick.
Only Robax ceramic or coated Neaoceram glass may be used for
replacement for model ZDV3628 and ZDV3632. Must be minimum
5mm thick.
To replace glass, clean all materials from door frame. Scrape off old
silicone down to metal. Using a high heat silicone temperature-resis-
tant to 500°F (260°C) apply a continuous bead of approximately 1/32"
to all four sides of frame and insert glass with new gasket. Frame
should be on flat surface, with a small amount of weight pressing glass
into silicone. Let dry approximately 15 to 20 minutes. The door can be
re-installed by reversing Steps 1 & 2. Use caution when removing
broken glass, wear gloves.
Removal of the Glass Door
1. Remove the two screws located behind upper grill or unfasten latch-
2. To remove, pull frame forward and lift from bottom door retainer
LOGC42 LOGC43 LOGC44 LOGC60
✔
✔
✔
10
es if so equipped.
channel.
✔ ✔
✔
✔ ✔
✔