General Glass Information; Confirming Proper Venting Of Appliance - Kingsman ZV3600N Installation Instructions Manual

Glass Cleaning
It will be necessary to clean the glass periodically. During start-up,
condensation, which is normal, forms on the inside of the glass and
causes dust, lint etc. to cling to the glass surface. Also, initial paint
curing can deposit a slight film on the glass. It is therefore recom-
mended that initially the glass be cleaned two or three times with non-
abrasive common household glass cleansers and warm water. After
that, the glass should be cleaned two or three times a season depending
on the circumstances.
Cautions and Warnings
• Do not clean when the glass is hot.
• The use of substitute glass will void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass front or with a broken
glass front.
• Do not strike or abuse glass.
To check for proper drafting, use this procedure.
1. Place unit in operation and let run for approx.1 minute to establish up a draft.
2. Open top grill area to expose the draft hood.
3. Using a match or something that will produce smoke, place it up to the opening of the draft hood and
verify that the flame or smoke is being drawn into the draft hood. If the flame or smoke is blown away
from the draft hood opening, you may have to re-check the venting and verify that there is a minimum
of 12 foot of venting or check the house for negative pressure.
If there is negative pressure, you will have to bring fresh air to the unit.
A Fresh Air Kit may be required by some building codes, remove cover plate on the bottom side of unit and
insert three inch flex duct into the side of fireplace by screwing it into the hole provided, attach the other
end to the plastic wall vent. When possible place the plastic vent below the bottom of the fireplace
left side only

General Glass Information

Confirming Proper Venting of Appliance

safety spill switch
check draft here
Fresh air inlet
Glass Replacement
REPLACEMENT GLASS FOR BOTH VENTED UNITS
Model Series ZV3600 or ZV4200 can use either tempered glass or
Robax ceramic or coated Neaoceram glass. Must be 5mm thick.
To replace glass, clean all materials from door frame. Scrape off old
silicone down to metal. Using a high heat silicone (temperature-resis-
tant to 500°F (260°C) apply a continuous bead of approximately 1/32"
to all four sides of frame and insert glass with new gasket. Frame
should be on flat surface, with a small amount of weight pressing glass
into silicone. Let dry approximately 15 to 20 minutes. The door can be
re-installed by reversing Steps 1 & 2. Use caution when removing
broken glass, wear gloves.
Removal of the Glass Door
1. Remove the two screws located behind upper grill or unfasten latch-
es if so equipped.
2. To remove, pull frame forward and lift from bottom door retainer
channel.
9