Weight Calibration - Intercomp CS3000 User Manual

Weight Calibration

One to ten load weights need to be applied to calibrate the scale. Using multiple point
calibration allows the unit to weigh more accurately; by removing undesirable
characteristics of load cells. A typical weight calibration is a three point calibration. This
means three different and optimal loads are applied and entered (not including the zero
point). If you do not conveniently have the three different weights available, you may
also use one or two point calibration. To calibrate with one point, simply turn off the
scale once the display shows "HH-02". To calibrate with two points, turn off the scale
once the display shows "HH-03". The CS3000 has the capability to apply and load up to
10 calibration points.
8. The display will show "SAvE" for about 1 second and advance to show "CAP". Press
the Mode button. The display will show the current capacity setting with the far right
number flashing. The flashing digit may be incremented by pressing the Lb/Kg
button or decremented by pressing the ZERO button. To move one digit to the left,
press the TARE button. Enter the capacity of the scale and press the Mode button
when the scale capacity is displayed.
9. The display shows "LL-00". With no weight applied to the scale press the Mode
button.
10. The display shows "HH-01". Press the Mode button. The display will show "00000"
with the far right number flashing. The flashing digit may be incremented by
pressing the Lb/Kg button or decremented by pressing the ZERO button. To move
one digit to the left, press the TARE button. Enter the value of the first load and
press the Mode button when the value of the first load is displayed.
11. The display shows "LL-01". Apply the first load to the scale. With the first load
applied to the scale press Mode button.
12. The display shows "HH-02". Press the Mode button. The display will show "00000"
with the far right number flashing. The flashing digit may be incremented by
pressing the Lb/Kg button or decremented by pressing the ZERO button. To move
one digit to the left, press the TARE button. Enter the value of the second load and
press the Mode button when the value of the second load is displayed.
13. The display shows "LL-02". Apply the second load to the scale. With the second
load applied to the scale press Mode button.
14. The display shows "HH-03". Press the Mode button. The display will show "00000"
with the far right number flashing. The flashing digit may be incremented by
pressing the Lb/Kg button or decremented by pressing the ZERO button. To move
one digit to the left, press the TARE button. Enter the value of the third load and
press the Mode button when the value of the third load is displayed.
15. The display shows "LL-03". Apply the third load to the scale. With the third load
applied to the scale press Mode button.
Page 21 of 35
CS3000, Users
Rev A, January, 2011