At the end of the activation phase the
steam injection system will need to be
cleaned to remove all traces of
descaling solution.
Cleaning is carried out by flushing
approx. 1 litre of fresh tap water
through the system. The water is
collected in the universal tray. This
process is repeated three times.
M Take the universal tray out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
N Detach the plastic tube from the
container.
O Rinse the container and fill with
approx. 1 litre of fresh tap water.
P Place the container back in the oven,
insert the plastic tube, secure it to
the container and close the door.
Q Touch the OK sensor.
Cleaning and care
The first rinse will be shown in the
display as E 2.
Water will be flushed through the steam
injection system and will then collect in
the universal tray.
R Take the universal tray out of the
oven and empty it. Place the tray
back in the oven again on the top
shelf level.
S Detach the plastic tube from the
container. Fill it with approx. 1 litre of
fresh tap water.
T Place the container back in the oven,
insert the plastic tube, secure it to
the container and close the door.
U Touch the OK sensor.
The second rinse will be shown in the
display as E 3.
V Repeat the last four steps.
The third rinse will be shown in the
display as E 4.
Leave the universal tray (with the
water which has collected in it) on the
top oven shelf whilst the evaporation
process takes place.
W Remove the container and tube from
the oven.
103