No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Is Not Correct - Fujitsu DESKPOWER C600 User Manual

No mouse pointer displayed on the screen

Shut down the operating system properly.
Switch the PC off.
Check that the mouse cable is properly connected to the system unit.
If you use an adapter or extension lead with the mouse cable, check the connections.
Make sure that only one mouse is connected.
Switch the PC on.
The mouse controller must be enabled if you use a PS/2 mouse on the PS/2 mouse port
Check in the BIOS Setup that the mouse controller is Enabled.
Check that the mouse driver is properly installed and is present when the application programme
is started. Detailed information can be found in the user guide for the mouse and application
programme.

The floppy disk cannot be read or written

Check whether the write protection of the floppy disk or the floppy disk drive is activated.
Check the relevant entries for Diskette A: or B: in the Main menu of the BIOS Setup.
Check that the floppy disk drive controller is enabled (refer to the "BIOS Setup" manual and if
necessary to the technical manual for the mainboard).
Check that the cables of the floppy disk drive are properly connected (refer to "Installing and
removing the floppy disk drive" chapter).

Time and/or date is not correct

You can set the time and date in the BIOS Setup or in the operating system.
Set the time and date.
If the time and date are repeatedly wrong when you switch on your PC, the on-board battery
is flat. Change the lithium battery as described in the "Extensions to the mainboard" –
"Replacing lithium battery" chapter.
.
31