Horizontal operating position with rubber / plastic feet
Disconnect the cables.
Position the device vertically.
Pull off the foil from the rubber / plastic feet.
Stick the rubber / plastic feet on the base of the casing.
To ensure stable position of the device the rubber / plastic feet should be fixed in similiar positions
as shown in the figure.
Place the unit on the rubber / plastic feet and reconnect any cables disconnected previously.
Horizontal operating position with base feet
Disconnect the cables.
Remove any bothersome rubber / plastic feet.
Take apart the base feet in the direction of the arrow.
Place the device on the base feet. Make sure that the device is lying level, straight and not tilted
on the base feet.
If necessary, reconnect the cables.
5