Bag D - Team Losi XXX4 Graphite Plus Owner's Manual

Step D-1
Front Inner Pivot Install
q
1. Install the front left Inner Pivot Block (47) by threading two 4-40
x 3/8" Flat Head Screws (134) through the bottom of the Chassis (46)
into the Pivot Block as indicated in Figure 36. Repeat for the right
front Inner Pivot Block (48).
The left & right Inner Pivots are marked with "L" & "R".
Step D-2
Front Arm Install
135
q
1. Slide a 1/8" inner Hinge Pin (101) through the larger holes of
each of the two Front Arms (53) at the same time passing through the
Hinge Pin Retainer (194) positioned as shown in Figure 37B.
q
2. Position the Arm so that the shock mount hole faces the front
of the Chassis (46). Place one Pivot Ball (49) on the rear of each Hinge
Pin and insert the Arm into the front Inner Pivot Blocks (47) L, (48) R.
Capture the Front Arms by placing the front Main Block (50) marked
with "7.5F" onto the inner Hinge Pins as shown in the illustration in
Figure 37B. Secure the front Main Block by threading two 4-40 x 1/2"
Flat Head Screws (135) through the Main Block into the holes in the
front Diff Cover (62).
q
3. After securing the front main block, thread a 5-40 x 1/8" Set
Screw (195) into the Hinge Pin Retainer and tighten to secure the
Hinge Pin.
Note: The Arm should rotate freely on the
Hinge Pin and not in the front Main Block or the
Pivot Balls. If the Arm does not pivot freely, use a
small file to remove a small amount of material
from the Arm where the Hinge Pin Retainer rests
against it.

BAG D

134
101
195
134
46
194
16
47
Figure 36
Figure 37A
ASSEMBLE MAIN BLOCK
IN THIS DIRECTION
Figure 37B