Team Losi XXX4 Graphite Plus Owner's Manual page 18

Step C-6
Servo Install:
q
1. Install the servo onto the Chassis (46). The pins from both
Servo Mounting Posts (34), (35) should fit into the holes and sit flat
against the Chassis.
q
2. Secure the servo to the Chassis with two 4-40 x 3/8" Flat Head
Screws (134).
Servo Link:
Step C-7
q
1. Thread a Short Plastic Rod End (10) onto each end of the 4-40
x 5/8" Set Screw (137). Tighten both sides equally until the Rod is the
same length as the one shown in Figure 34B.
Servo Link Install:
Step C-8
q
1. Attach one Rod End (10) to the Ball Stud (80) in the Servo
Saver Arm (39), and the other to the Ball Stud in the Drag Link (32), as
indicated in Figure 35.
BAG C (Continued)
134
137
10
10
80
32
15
Figure 33
46
Figure 34A
10
137
Figure 34B
Figure 35
137
39
34
134
81