Team Losi XXX4 Graphite Plus Owner's Manual page 8

Diff Pulley:
Step A-14
q
1. Insert a 5mm x 8mm Bearing (117) into the center of the 42T Diff
Pulley (42).
q
2. Press a 3/32" Diff Ball (82) into each of the small holes in the
Diff Pulley as indicated in Figure 14.
Step A-15
Diff Pulley to Diff Tube:
q
1. Apply a moderate coat (continuous bead, same as step A-9) of
Clear Diff Grease (172) to the exposed side of the Diff Ring (108) that
is already attached to the Male Outdrive (87).
q
2. Carefully place the Diff Pulley (42) over the post on the
Outdrive so that the Diff Balls (82) and Diff Pulley rest against the
Greased Diff Ring. Leave the assembly with the 1/16" Allen Wrench
(125) standing as shown in Figure 15.
BAG A (Continued)
82
117
Figure 14
42
108
5
42
82
117
82
Figure 15
CLEAR DIFF
GREASE (172)
87
FIGGIGUREFASDF