Team Losi XXX4 Graphite Plus Owner's Manual page 21

MIP CVD TABLE
*NOTE: See Table 40 for part numbers and names of all items
referred to in the MIP CVD kit for the front of the XXX-4 G+.
CVD Axle Assembly
Step D-5
114A
q
1. Apply a thin coat of Red MIP Thrust Bearing/Assembly Grease
(157), (from the white tube), to the outside of the CVD Coupling (114A).
Insert the greased CVD Coupling into the large hole in the CVD Axle
(114D) so that the cross-hole in the Coupling can be seen through the
slots in the Axle.
q
2. Place the CVD Bone (114E) over the CVD Axle. Align the holes
in the CVD Bone with the hole in the CVD Coupling. Secure all three
parts by inserting a 1/16" x 7/16" (solid) Pin (114B) through the holes
in the CVD Bone, the slots in the CVD Axle, and the hole in the CVD
Coupling.
q
3. Apply a small amount of Thread-lock Compound (158) (Found
in Bag E, in the CVD Bag, the black tube) to the Set Screw (114C)
before installing it.Center the Pin in the CVD Bone and secure it by
threading a 4-40 x 1/8" Set Screw into the threaded end of the CVD
Coupling.
q
4. Repeat Steps 1-4 for the second CVD assembly.
Apply the enclosed Thread-lock to the Set Screw before thread-
ing it into the CVD Coupling. If Thread-lock is not used, the Set
Screw will loosen during operation. This will cause your car to stop
running.
Step D-6
CVD Axle to Spindle Assembly
81 114F
116
q
1. Thread a 3/16" Ballstud (81) through the top side of the left
Spindle Arm (16) and into a 4-40 x 3/16" Mini Nut (183). as shown in
Figure 42A.
q
2. Install a 3/16 x 3/8" Bearing (116) with the teflon seal facing
out, in the back side of the left Spindle. From the front side, install the
Bearing Spacer (114F) followed by another 3/16 x 3/8 Bearing with the
teflon seal facing out.
q
3. Insert the assembled MIP CVD (114D) through the Bearings
in the left Spindle. Install the MIP Hex Adapter (114H) over the Axle
with the cut-out section facing away from the Bearing. Align the slot
in the Hex Adapter with the holes in the Axle and insert a 1/16 x 5/16"
(Roll) Pin (114G) through the two until flush on both sides.
q
4. Repeat steps 1-3 for the right Spindle (15) assembly.
BAG D (Continued)
114B 114C
183
114G
MIP CVD KIT FRONT XXX-4 G+
PART # NAME
114A Coupling
114B Solid Pin
114C Set Screw 114H
114D Axle
114E CVD Bone
Figure 41
114E
114B
114H
116
114G
114F
114H
18
PART # NAME
114F Bearing Spacer
114G Roll Pin
Hex Adapter
114J 8-32 Locknut
Table 40
MIP
THREAD
LOCK
(158)
114C
114D
Figure 42A
114D
81
183
Figure 42B
16
Right
MIP
RED
LUBE
(157)
114A
Left