Team Losi XXX4 Graphite Plus Owner's Manual page 31

Rear Shock Install
Step F-6
184
q
1. Position the bottom of an assembled rear Shock in front of the
Shock mounting area on the left rear suspension Arm (11) as shown
in Figure 67. Align the hole in the Shock Mount Ball (78) with the
inside hole in the Arm.
q
2. Attach the Shock to the rear Arm by threading a 4-40 x 1/2" Cap
Head Screw (129) through the Shock Mount Ball into the inside hole
of the suspension Arm.
q
3. Slide a "long" Shock Mount Bushing (25), large side first, over
the Screw (130) on the left side of the Tower.
Before attaching the top of the Shock, make sure that the drive
end of the CVD is in place in the Outdrive.
q
4. Place the top of the Shock Body (85) over the Shock Mount
Bushing. Secure the Shock to the Tower by threading a 4-40 Locknut
(184) onto the Shock Mount Screw.
q
5. Repeat Steps 1-4 for the right side rear Shock Assembly.
Front Shock Install
Step F-7
26
q
1. Position the bottom of an assembled front Shock in front of the
Shock Mounting area on the left front suspension Arm (53) as shown
in Figure 68. Align the hole in the Shock Mount Ball (78) with the
inside hole in the Arm (53).
q
2. Secure the Shock to the Arm by threading a 4-40 x 1/2" Cap
Head Screw (129) into the Arm from the front side.
q
3. Slide a "short" Shock Bushing (26), large side first, over the
Screw (130) on the left side of the front Shock Tower.
Before attaching the top of the Shock, make sure that the drive
end of the CVD is in place in the Outdrive.
q
4. Place the top of the front Shock Body (84) over the Shock
Mount Bushing on the Tower. Secure the shock assembly to the
Tower by threading a 4-40 Locknut (184) onto the Shock Mount Screw.
q
5. Repeat Steps 1-4 for the right side front Shock assembly.
BAG F (Continued)
25
129
129
184
85
25
184
11
129
78
26
84
184
129
Figure 68
28
130
Figure 67
130
78
53