Team Losi XXX4 Graphite Plus Owner's Manual page 28

Swaybar Link Assembly
Step E-10
137
q
1. Thread a Plastic Rod End (4) onto each end of a 4-40 x 5/8" Set
Screw (137). Tighten both sides equally until the Rod is the same
length as the one shown in Figure 59B. Make two of these assem-
blies.
Rear Camber Tierod Install
Step E-11
q
1. Place a "Foam Thing" (185) over the Ball Stud (107) in the left
rear Hub Carrier (23). Place a second "Foam Thing" over the Ball Stud
(33) in the rear Shock Tower (58).
Assure that the drive end of the CVD Bone is inserted in the
Outdrive before attatching the Tierod.
q
2. Snap the end, closest to the groove, of the Turnbuckle to the
Ball Stud in the left rear Hub Carrier. Snap the other end to the Ball
Stud in the rear Shock Tower. Repeat Steps 1-2 to attach the other
Tierod assembly to the right rear Hub Carrier (24) assembly.
Assure that the grooves on all of the rear Turnbuckles are
located on the drivers left-hand side for easier adjustment later.
Step E-12
Battery Post Install
162
131
q
1. Install the Battery Mount Posts (68) to the Chassis (46), as
shown, by placing the square base of the Post in the countersunk
pockets on the drivers right side of the Chassis.
q
2. Thread a 4-40 x 3/8" Cap Head Screw (131) through the bottom
of the Chassis into each of the Battery Mounting Posts and tighten.
q
3. One Body Clip (124) will be inserted into the holes on the top
of each Battery Post at a later step in this manual.
q
4. Peel the backing off the Battery Insulation Tape (162) and
allign the cut-outs in the tape with the appropriate placeson the Chas-
sis and apply the Tape to the Chassis as indicated in Figure 61.
BAG E (Continued)
4
33
185
APPLY CHASSIS
TAPE (162) HERE
68
25
Figure 59A
Figure 59B
Figure 60
58
133
4
107
81
23
4
185
Figure 61
131
124
46