Bag C - Team Losi XXX4 Graphite Plus Owner's Manual

Steering Bellcrank Assembly:
Step C-1
81
q
1. Thread a 3/16" Ball Stud (81), from the top side, into each of the
Left (30) and Right (31) Bellcranks.
q
2. Insert a 5mm x 8mm Bearing (117) into the top and bottom of
the Left and Right Bellcranks.
q
3. Thread a 3/16" Ball Stud (81) into the small hole in the Draglink
(32).
q
4. Insert the 2 Carrier/Steering Bushings (100), into the bottom
side of the Draglink and then rest it on the top of the Left and Right
Bellcranks.
q
5. Thread a 4-40 x 3/8" Button Head Screw (142) through each
Steering Bushing and into the Bellcranks.
Steering Install:
Step C-2
134
q
1. Line up the hex of a Steering Post (97) with the rear hex area on
left side of the Chassis (46). Press the Steering Post to the bottom of
the hex. Thread a 4-40 x 3/8" Flat Head Screw (134) through the bot-
tom of the Chassis and into the Steering Post.
q
2. Repeat Step 1 for the right side Steering Post.
q
3. Slide the Bellcrank assembly from Step C-1 through the Steer-
ing Tunnel (29) and then slide the Left Bellcrank (30) over the Steer-
ing Post on the left side of the Chassis.
q
4. Sliding the Right Bellcrank (31) over the right Steering Post will
need to be done at the same time as the Left Bellcrank.
The Bellcranks should rotate freely.

BAG C

142
117
81
31
LARGE HOLES
FORWARD
32
31
30
12
81
32
100
30
Figure 28
46
Figure 29
29
97
134