Securing the Base
When mounting the B‐Series touchcomputer, the baseplate must be removed
and mounted on a flat surface. Use the four pre‐tapped holes to secure the
baseplate from below the mounting surface before reattaching the
touchcomputer as shown below. The holes are designed to work with ISO metric
M6 screws. Mounting screws are not included with the product. Refer to the
figure below for the location of the holes. All dimensions are in millimeters.
Mounting Diagram
1)
2)
User Guide – B-Series Rev-B AiO Touchcomputer
SW602032 Rev C, Page 8 of 47