Ftp Service Setting; Alarm Server - Wansview NCB-541W User Manual

http://www.wansview.com
The device will send alarm email to you. You only need to fill out the blanks with your
email address as shown in Figure 20. After the setting, please click save and test to
check if it works properly. If it is properly set, user can tick to enable "Report Internet IP
by mail". After every restart, the device will send its Internet IP address to user's email
address.

5.2.3 FTP Service Setting

When alarming, device will snap and send the image to FTP server, please make sure
the FTP setting is correct. Above Figure 21 of FTP setting for your reference, after the
setting is finished, click "Test" to test your settings are correct or not.
After correct setting FTP server, you can use "upload Image Periodically" function. Even
no alarm, device can also send the snap image to FTP periodically.
In order to use FTP function, user should apply username and password on the FTP
server first. And please apply some storage, and the authority to write and create
sub-category into it.

5.2.4 Alarm Server

Please confirm if you have connected to alarm server. The alarm message format as
follow:
GET /api/alarm.asp？
username=username&
Figure 21
Figure 22
17