10. Install and lock the left-side cover (see "Installing the left-side cover" on page
11. Reconnect the external cables and power cords; then, turn on the attached
Removing an extender card
To remove an extender card, complete the following steps:
1. Read the safety information that begins on page 5.
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
9. Close the bezel (see "Closing the bezel" on page 151).
158).
devices and turn on the server.
1
Extender card retaining screws
and external cables.
up.
Attention:
Do not allow the server to fall over.
Chapter 7. Installing optional devices and replacing customer replaceable units
207