Installing The Front Adapter-Retention Bracket - Lenovo THINKSERVER 3822 Hardware Maintenance Manual

3. Unlock and remove the side cover (see "Removing the left-side cover" on page
4. Open the front and rear adapter-retention brackets.
5. Remove all adapters and place the adapters on a static-protective surface (see
6. Lift the top of the front adapter-retainer bracket and release the hinge point;
7. If you are instructed to return the front adapter-retention bracket, follow all

Installing the front adapter-retention bracket

To install the front adapter-retention bracket, complete the following steps:
1. Insert one hole on the front adapter-retention bracket into the hinge point.
2. Position the other hole and insert the adapter-retention bracket into the hinge
3. Install the adapters (see "Installing an adapter" on page 184).
4. Close the front and rear adapter-retention brackets.
5. Install and lock the side cover (see "Installing the left-side cover" on page 158).
6. Reconnect the external cables and power cords; then, turn on the attached
157).
"Removing an adapter" on page 184).
Note: You might find it helpful to note where each adapter is installed before
you remove the adapters.
then, remove the bottom hinge point and remove the bracket from the chassis.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
point.
devices and turn on the server.
Chapter 7. Installing optional devices and replacing customer replaceable units
181