Connecting The Cables; Updating The Server Configuration - Lenovo THINKSERVER 3822 Hardware Maintenance Manual

Connecting the cables

Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
2. For additional cabling instructions, see the documentation that comes with the
3. Cable identifiers are printed on the cables that come with the server and
The following illustration shows the locations of the input and output connectors on
the rear of the server.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup Utility
starts automatically so that you can save the new configuration settings. For more
information, see Chapter 9, "Configuring the server," on page 251.
234
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
any cables from the server or hot-plug adapter.
optional devices. It might be easier for you to route any cables before you install
certain optional devices.
optional devices. Use these identifiers to connect the cables to the correct
connectors. For example, the hard disk drive cables are labeled "HDD option."
1
USB 1
2
USB 2
3
USB 3
4
USB 4
5
Ethernet 10/100/1000
6
Power cord connector
7
Power-error LED
8
dc-power LED
9
ac-power LED
10
Video
11
Serial 1 (COM 1)
12
Systems management