Power; Pairing; Discovering; Connect To - KoamTac KDC400 User Manual

Bluetooth Service

4.17 Power

The POWER option allows you to Enable or Disable the Bluetooth functionality of the KDC. To use Bluetooth,
this option must be set to Enable. However, like all devices enabled for Bluetooth, the KDC will search
constantly to connect with a Bluetooth host when set to enable. Constant searching uses battery power.
Unless you are using Bluetooth with your KDC, this option should be set to Disable.
IMPORTANT: To prevent unnecessary power problems, it is strongly recommended that the POWER option
be set to Disable if the KDC is idle for an extended period of time.

4.18 Pairing

Before you are able to use Bluetooth, the KDC must be paired with the host device. This paring
process only needs to be completed once with each host device. After pairing, the host device will
always recognize the KDC as a Bluetooth device unless the Bluetooth configuration is modified. If it is
modified, you may need to pair the devices again.
IMPORTANT: The host device must be configured for Bluetooth before it can be paired to the KDC.
[NOTE] KDC with Bluetooth Spec2.1+EDR doesn't prompt Pin code entry menu
To pair the KDC with the host, follow these instructions.
1. Scan Pairing special barcode.
2. When prompted by the host device, enter the Security PIN "0000".
3. The "Short beep" will sound when the Bluetooth connection is successfully established. The
connection must be established before the pairing timeout which is 60 seconds.
[Note] Users may have to use the host Bluetooth manager to connect KDC and host after pairing process.

4.19 Discovering

KDC200/250/300/400 starts to search neighboring Bluetooth device if this Discovering menu is executed. It
would take about 30 seconds to finish search and lists available neighboring Bluetooth devices. Use may
enter corresponding Bluetooth MAC address in KTSync Bluetooth menu instead of searching neighborhood
Bluetooth devices.

4.20 Connect To

This option lets you easily connect KDC to Bluetooth devices either previously registered in KTSync under
the File Menu or discovered/connected from KDC Bluetooth Service menu
53
KDC400 User Manual