KoamTac KDC400 User Manual page 43

AIM ID - Allows you to add AIM ID to scanned data which can then be stored in KDC or wedged
to the host. AIM ID must be defined in data format menu of KTSync. AIM ID is either added to
the end of Prefix or Suffix.
Partial Data: Allows you to store and/or transfer partial data. User defines the start position and
number of characters to be stored and/or transferred.
Select the x characters from y position
Set Partial Data Start Position to y, Partial Data Length to x, Partial Data Action to
Select
Partial Data Length 0 means Select all characters from y position.
Erase the x characters from y position
Set Partial Data Start Position to y, Partial Data Length to x, Partial Data Action to
Erase
Partial Data Length 0 means Erase all characters from y position.
Handshake - KDC provides Handshake mode when Data Format is set to Packet Data.
Handshake Mode will increase the reliability of barcode data transmission.
The default mode for Handshake is Disabled.
Data transmission speed is slower when Handshake Mode is Enabled.
Terminator – KDC supports various termination characters when the Data Format mode is set to Barcode
Only. This option allows you to select <NONE>, <CR>, <LF>, <CR+LF>, or <TAB> as the termination
character. The default terminator is <CR+LF>. Up/Down/Left/Right arrow terminator is also available for HID
mode.
Chk Duplicate – This option allows you to prevent collecting duplicated data.
43
KDC400 User Manual