Bt Config Menu - Kdc200/250/300/400 - KoamTac KDC400 User Manual

BT Config Menu - KDC200/250/300/400

The KDC supports Bluetooth Ver2.1+EDR. Before utilizing the advantages of Bluetooth functionality with
the KDC, you should become familiar with Bluetooth connectivity and its impact on your host environment.
To configure your KDC for Bluetooth functionality, you must use the KDC Menus. To access the menus,
simultaneously press the UP and DOWN scroll buttons on the side of the KDC. Use the DOWN button to
scroll to Bluetooth then press the Scan button.
Below is a listing of the Bluetooth options and their settings. The default settings for these options have
been set to increase the usability of Bluetooth technology without compromising the KDC battery usage.
IMPORTANT: We strongly recommend NOT changing these settings until you have fully tested the
Bluetooth connection between the KDC and the host device.
For more detailed information regarding Bluetooth functionality with the KDC, please refer to Chapter 4.
ConnectDevice
SPP, SPP2.0
o
HID normal
o
HID iOS (KDC200i/250i/300i/400i)
o
iPhone (KDC200i/250i/300i/400i)
o
Auto Connect - Enabled or Disabled
Auto Power On - Enabled or Disabled
PWR On Time – Disabled, 1 to 10 seconds
o
Auto Power Off - Enabled or Disabled (KDC250 should use option in system menu)
Beep Warning - Enabled or Disabled
o
PWR Off Time - 1 to 30 Minutes
o
PowerOff Msg – Enabled or Disabled
MAC Address – 12 characters Bluetooth MAC Address
FW Version – Display Bluetooth Firmware Version
Wakeup Nulls – Enabled or Disabled
Autolock Time – 0, 1, 2, 3, 4, 5, 10, 15 minutes
BT Toggle – Enable or Disable HID soft keyboard or iPhone mode connection On/Off toggle.
HID AutoLock - Disabled, 1, 2, 3, 4, 5, 10, 15 minutes
HID Keyboard – English, German, French, Spanish, Italian
HID Initial Delay
Define the initial delay between 1sec to 10sec before data transmission in HID mode
o
HID Inter-character Delay
Define the inter-character delay between 10msec to 100msec in HID mode
o
HID Control Character
Map control characters to either ALT+Numlock or ^+Character
o
`
44
KDC400 User Manual