Reset Feature; Replace Battery - KoamTac KDC400 User Manual

3.7 Reset Feature

The Reset feature lets you restart the KDC if necessary without losing any stored barcode data or option
settings. To reset the KDC, follow these steps.
Press DOWN scroll button and SCAN button simultaneously for 5 seconds.
1.
When the LEDs illuminate yellow, release the buttons.
2.
The KDC initial screen, KoamTac Data Collector KDC displays when reset is complete.
3.
Note:
The KDC stores collected data into flash memory and will not lose data or the KDC settings
during the reset process.

3.8 Replace Battery

KDC300 comes with a rechargeable, Lithium-Ion battery. The battery is recharged from any USB port
and can be recharged about 300 times before it needs to be replaced.
KoamTac recommends replacing the battery every six months as a declining battery will cause
noticeable performance degradation in KDC400. Replacement batteries can be purchased from a
KoamTac distributor. Batteries should be disposed of properly.
The steps for replacing the battery are as follows.
Disassemble the KDC400 smartphone case by unscrewing screws.
1.
Remove old battery and replace with new battery.
2.
Reassemble the KDC400 smartphone case.
3.
48
KDC400 User Manual