Bt Service - Kdc200/250/300/400; Gps Config - Kdc250; System Menu - KoamTac KDC400 User Manual

BT Service - KDC200/250/300/400

Power
Enable or Disable Bluetooth Power
o
Pairing Mode
KDC enters pairing mode so that host Bluetooth device can search KDC.
o
KDC exits pairing mode either by pressing the scan button or it fails to pair with Bluetooth host
o
device in 90sec.
Discovering
Search neighborhood Bluetooth devices
o
Connecting To
Inquiry to registered Bluetooth devices
o
HID Sync
KDC transmits all stored data to the host over HID profile if HID Sync option is enabled
o

GPS Config - KDC250

GPS Power
Enable or Disable GPS Power
o
Power Mode
Normal or Power Save
o
Bypass Data
Enabled or Disabled
o
Acquire Test
Acquiring time test of GPS signal
o
Reset GPS
Reset GPS parameters
o

System Menu

Memory Size (3.0 version only)
User can select normal data and application database memory partition size.
KDC will erase all stored data upon changing the partition size.
User should enter the following key sequence to change the partition.
<Up key> + <Up key> + <Down key> + <Down key> + <Scan button>
Memory Status: Checks the number of stored barcodes and memory usage.
Reset Memory: Resets KDC memory by erasing all stored barcodes, application and BT registry.
Auto Erase: Erases all stored barcodes upon reaching buffer full condition if Enabled is selected
Sleep Timeout: Sets amount of time KDC waits, when not being used, before going to sleep.
Auto Power Off (KDC250 only)
Bluetooth: Enabled/Disabled
GPS: Enabled/Disabled
Power Off Time:0(Never), 5, 10, 20, 30, 60, 120 seconds
Date/Time: Sets the date and time of KDC which can also be set using KTSync
45
KDC400 User Manual
®