Operating The Kdc; Getting Started; Attach Hand Strap To Kdc; Charge Kdc Battery - KoamTac KDC400 User Manual

3. OPERATING THE KDC

3.1 Getting Started

Attach Hand Strap to KDC

To prevent possible damage to the KDC, we strongly recommend wearing it around your hand by the
included hand strap. Also, please don't swing KDC by the hand strap because contact with another
object may cause it to malfunction or become damaged.
To attach the hand strap:
1. Fit the thin end of hand strap through the pillar of the KDC.
2. Loop the thick end of strap through the thin loop
3. Pull the strap tight to secure

Charge KDC Battery

Prior to using the KDC, you must charge its battery. To charge the battery, follow these directions.
1. Connect the KDC cable to the ultra mini USB connector on the KDC.
Connect the KDC cable to Type A USB connector on your computer.
2.
3. Your KDC battery will begin charging. Within a few minutes, two small LEDs on the front panel will
illuminate orange. When the battery is fully charged, the LEDs will illuminate green.
KDC100
2 Hours
Table 2 – Approximate Time to Charge KDC Battery
KDC200 KDC250/300
2 Hours 4 Hours
28
KDC400 User Manual
KDC400
5 Hours