Data Process Menu - KoamTac KDC400 User Manual

Image Capture (KDC420/425 only): Allows you to capture an image in JPEG format in C:\myData folder.
User should enable the image capture option first then press the scan button to start the aiming. Green
aiming light will illuminate and take an image upon release of the scan button. KDC300 will disable the
image capture option if user presses the scan button for 10 seconds.
Auto Trigger: Allows users to scan a barcode automatically once Auto Trigger is enabled. USB
cable connection requirement has removed from FW version 2.85/86.O and 3.02.
Reread Delay: Users can adjust Reread delay from Continuous to Extra Long. Auto Trigger mode
always enables duplicate check option.
Partial Display: Allows you to display partial data. User defines the start position and number of
characters to be displayed.

Data Process Menu

Wedge/Store - The KDC provides five modes of data transmission in keyboard wedging mode.
Wedge Only: Barcode data is NOT stored in memory but transmitted to the host.
Wedge & Store Only: Barcode data is stored in memory and transmitted to the host.
Store Only: Barcode data is stored in memory but NOT transmitted to the host.
Save if Sent: If data transmission is successful, barcode data is stored in memory.
Save if Not Sent: If data transmission is NOT successful, barcode data is stored in memory.
Data Format - The KDC provides two data formats, Barcode Only and Packet Data.
Barcode Only: KDC transmits scanned barcodes only. User may incorporate proper data
transmission error detection and correction mechanism in this mode.
KDC supports various termination
characters for barcode only format.
User can select <NONE>, <CR>, <LF>,
<CR+LF> or <TAB> as the termination character.
Packet Data: KDC transmits packet data with checksum to minimize transmission errors.
KTSync
User may change Data Format to Barcode only if user prefers to use Barcode only
mode but either KTSync program terminates abnormally or user disconnects KDC
without exiting KTSync program normally.
[Note] Barcode Index: KDC200i/250i/300i/400i add 4 bytes barcode index to maintain last
synchronized barcode information. This optional index would be added if data format is "Packet
Data" and
®
sets Data Format to Packet Data format upon execution.
39
KDC400 User Manual