Table of Contents
Advertisement
protocols (TCP/UDP/ICMP/IP); and then define the Source Port (range) and Destination Port
(range); click Apply to save this protocol .
If the Protocol Type is ICMP, it will need to define Type and Code.
If the Protocol Type is IP, it will need to define Protocol Number.
2. Rules
After the custom protocol is defined or just use the Predefined Service Protocols, you will need to
enable the Firewall Rule to apply these protocols.
Firewall Rules: Click the number of Filter Rule No. to edit individual rules and click Apply
o
to save the settings. The rule status will show on the list. Check "Active" checkbox and click
Apply to enable that rule.
This link leads to the Firewall Rules page. Rule No.1 has the highest priority; Rule No.2 has
the second priority and so on. Each firewall rule is defined by Source, Destination and
Pass/Block action. Optionally, a Firewall Rule Schedule can be set to specify when the firewall
rule is enforced. It can be set to Always, Recurring or One Time.
AMG-2102 Gigabit Access and AP Management Gateway Pro
102
User's Manual
Advertisement
Table of Contents
