Installing The Hc34Df* Log Set (Previous Model Hd34Df*) (Part # Lgs44P); Installing The Logs - Montigo H34DF Installation & Maintenance Manual

H*34DF Indoor Gas Fireplace
Installing the HC34DF* Log Set (Previous model HD34DF*)
(Part # LGS44P)

Installing the Logs:

The HC34DF* is supplied with a seven piece ceramic fibre logset. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous instruction.
Upper Logs
Figure 29a. HC34DF's seven piece logset.
Step 2 Place the Rear Log in position at the back of the fireplace as
shown in Figure 29b below.
Base Log
Figure 29b. Rear Log placement.
Step 3. Place the Front Log in position just behind the black grate as
shown in Figure 29c below.
Figure 29c. Front Log placement.
Step 4. Place the top logs from left to right in the order as shown in
Figure 29a. These logs balance in the grooves of the base logs
and do not lock into place.
Page 28
Installation
Step 5. Place the left two logs, and the centre log shown below in
Rear Log
Front Log
Figure 29d. Left and Center log placement.
Step 6. Place the right two logs as shown in figure 29e.
Figure 29e. Right log placement.
Step 7. Start the fireplace. If the flame appears satisfactory, replace
If logs are not placed properly, excessive sooting will result.
figure 29d.
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.
NOTICE
XG0146 - 150204