Montigo H*34-DF Installing

Installing the HFK50R Fan Kit for Proflame 2
For use with:
H*34-DF/DL; L38-DF
H*38-DF/DL; L42-DF
H*-DF/DL; L52-DF
* = C, L, P, R, W

General Information

This blower kit is for installation with the models listed above.
KIT # Contents
HFK50R 2x blowers, 1x fan cord assembly, 4x mounting screws,
Velcro strips, self-adhesive cable tie mounts and cable
ties.
HFK50R
Required: This fan kit requires one of the remote control
kits (PF2 Remote Kit or RX 100*) for proper operation.

Before You Begin

Ensure that the power supply has been turned off at the breaker or
fuse before beginning the installation.
Shut off the gas supply at the shut-off valve, and ensure that the main
burner and pilot light have been turned off and the fireplace has been
cooled off for at least two hours before installation.
Cable ties &
mounts
Right fan Left fan
Figure 1
Contents of HFK50R Fan Kit package.
Page 1
This kit should be installed by a qualified person.

®
Check local codes and read all instructions prior to installation.

C US
Fan mount-
ing screws
Fan wire harness
CAUTION
Ensure that all power to the appliance is off at the electrical breaker or fuse
before beginning installation. Ensure gas is turned off at the shutoff valve before
beginning installation.
Installation
1. Remove burner tray if required.
Burner Tray Gasket
Figure 2
Removing the burner tray (L38DF, L42DF, L52DF
models only).
Burner Tray Gasket
Figure 3
Removing the burner tray (L38DF, L42DF, L52DF
models only).
Fan Kit
17
18
XT0015 - 092214