Installing The Driftwood Log Set - Montigo PL42DF Installation & Maintenance Manual

Installing the Driftwood Log Set

The PL42DF* has the option of installing a drift wood log set. Once
the firestones or speckled stones have been installed the log set
can be installed.
Ensure logs are securely placed and will not tip or fall. Remove
media where logs touch the burner tray to ensure a more secure
position.
Lean the logs against the back panels. NO LOGS SHOULD LAY
ACROSS OR OVER TOP OF THE BURNER PORTS ON THE SURFACE
OF THE BURNER.
Step 1. Remove the glass door as described in the
previous section.
Step 2. Ensure selected media is installed according to
Section 9 instruction as shown in Figures 24 - 24d or
25 - 25a.
Step 3. Unpack the logs and handle with care.
1
3
2
Figure 26.
1
2 3
Figure 26a.
Step 4. Place Log 3 from LGS58 in the back right corner
of the burner tray. Ensure log does not cover ports.
Place Log 2 of LGS58 on top of log 3.See Figure 26b.
XG0217 -160215.1
Installation
LGS58
5
4
LGS59
6
4 5
2
Ports
Figure 26b.
Step 5. Place Log 5 from LGS58 on top of Log 2. Place
Log 1 from LGS58 on top of log 2, see Figure 26c.
Ports
Figure 26c.
6 Pilot
Ports
Figure 26d.
Step 6. Place log 6 of LGS59 across of log 1 of LGS58,
see Figure 26e.
Ports
Figure 26e.
PL42DF* Indoor Gas Fireplace
1
5
6
Page 27