H*34DF Indoor Gas Fireplace
3.
Remove the Rock Guard and River Rocks from packaging.
4.
Install the new Rock Tray and front cover. Make sure the tray is not
sitting on top of the pilot.
Rock Tray
Figure 31c. Burner Tray Front Cover
5.
Slide the rock guard locator tabs behind the Burner. The rocks on
the Rock Guard should line up between the air inlets of the burner.
Figure 31d. Pushing the Rock Guard down into place.
Figure 31e. Completed Placement of Rock Guard.
Page 30
Installation
Installing the Designer River Rocks:
The HR34DF* is supplied with (40) forty faux ceramic fibre river rocks.
Unpack the rocks and handle them very carefully. Shown Below:
Front Cover
Step 1. Remove the glass door as described in the previous instruction.
Figure 32a. Firebox prior to faux ceramic fibre rock installation.
Step 2. Install Rear faux "A" ceramic 3 in1 Rock as shown in Figure
Rock placement
Figure 32b. Placement of faux ceramic rock "A" (flat surfaces of rock against the
back and bottom pan of the fireplace). Note decreasing size of rock diameters.
Step 3. Next, Install Centre (2) Two faux "B" and "C" ceramic 2 in 1 Rock
Top View
Side View
3 in 1 faux Rock "A"
1-pc
Side
Top
View
View
Rock "E"
32-pcs
Back of Fireplace
Pilot and cover
Air Inlets
32b.
3 in 1 faux Rock "A"
Note: Ensure the rocks do not cover
as shown in Figure 32c.
the Burner holes, (reference lines of burner holes (straight
lines) and outline or rocks (ovals) shown above, Figure 32b.)
Top View
Side View
2 in1 Faux Rock "B & C"
2-pcs
Burner holes
Side
Top
View
View
Rock "D"
5-pcs
Burner holes
Burner holes
XG0146 - 150204