Section 8: Installing The Log Set - Montigo H36PVN Installation & Maintenance Manual

H36PVN Power Vent Indoor Gas Fireplace

Section 8: Installing the Log Set

Installing the Logs:
The H36PVN is supplied with six (6) piece ceramic fibre logs. Install
as described below:
Step 1. Unpack the logs and handle them very carefully. Set them
aside in a safe location until required.
Figure 18. Packaged LogSet as supplied from Montigo.
Log A
Alignment Tab
Log C Rest
Log D Rest
Log D
Spikes
Log E Spike
Figure 18a. Log Grate Details & identification.
Locate the Log Back Pan Retaining clip, Figure, 18a above
Step 2.
and remove, Figures, 18b & 18c. Place in a safe location
(Philips head screwdriver required).
Figure 18b.
Page 28
Installation
Log A Retaining Clip
Log A back-pan
Log A Spikes
Log B cradle
& Spike
Log B Rest
Log C
Left end Rest
Spikes
Figure 18c.
Step 3. Position Back Log 'A' from the previously unpacked package,
(Figure 18). Place the Log upright, (as shown Figure 18d) and
move the Log flush against the sheet metal Back Pan. Without
pressing the Log down, move it as far to the left as possible,
bumping the bottom Left corner against the alignment tab,
(Figure 18a & 18d). Lastly, Press the Log FIRMLY downward,
onto the sharp spikes, shown in Figure 18a & 18e.
Figure 18d. Location of Log 'A'.
Move Log 'A' left
and bump against
Alignment Tab
Alignment Tab
Figure 18e. Alignment of Log 'A'.
Step 4. Once the 'Back Log 'A' is in it's final Position, hold the log
in place, and reinstall the Retaining Clip (removed earlier).
Press down the Clip for the sharp teeth to penetrate into the
top of the Log. (Figure 18g). (Philips head screwdriver
required).
Figure 18g. Securing Log 'A'.
Log A
Log 'A' Spikes
Figure 18f. Log 'A' Spikes, Figure 18a.
XG0649 - 180130